RAM 3500 Truck 4WD V8-5.9L VIN Z LDC (2000)
Camshaft: Removal and Replacement
Fig. 51
NOTE: The camshaft has an integral oil pump and distributor drive gear (Fig. 51).
REMOVAL
1. Remove the radiator. Refer to Cooling System for the correct procedures.
2. Remove the A/C Condenser (if equipped)
3. Remove the engine cover.
4. Remove intake manifold.
5. Remove cylinder head covers.
6. Remove timing case cover and timing chain.
7. Remove rocker arms.
8. Remove push rods and tappets. Identify each part so it can be installed in its original location.
9. Remove distributor and lift out the oil pump and distributor drive shaft.
Fig. 52
10. Remove camshaft thrust plate, note location of oil tab (Fig. 52).
11. Install a long bolt into front of camshaft to aid in removal of the camshaft. Remove camshaft, being careful not to damage cam bearings with the
cam lobes.
INSTALLATION
1. Lubricate camshaft lobes and camshaft bearing journals and insert the camshaft to within 51 mm (2 inches) of its final position in cylinder block.
