RAM 3500 Truck 4WD V8-5.9L VIN Z LDC (2000)
Ignition Coil: Service and Repair
The ignition coil is an epoxy filled type. If the coil is replaced, it must be replaced with the same type.
Ignition Coil
The coil is mounted to a bracket that is bolted to the air injection pump (AIR pump) mounting bracket.
REMOVAL
1. Disconnect the primary wiring from the ignition coil.
2. Disconnect the secondary spark plug cable from the ignition coil.
3. Remove ignition coil from coil mounting bracket (two bolts).
INSTALLATION
1. Install the ignition coil to coil bracket. If nuts and bolts are used to secure coil to coil bracket, tighten to 11 Nm (100 in. lbs.) torque. If the coil
mounting bracket has been tapped for coil mounting bolts, tighten bolts to 5 Nm (50 in. lbs.) torque.
2. Connect all wiring to ignition coil.
