RAM 3500 Truck 4WD V8-5.9L VIN Z LDC (2000)
Power Door Lock Switch: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect and isolate the battery negative cable.
Power Window and Lock Switch and Bezel Unit Remove/Install
2. Using a wide flat-bladed tool such as a trim stick, gently pry the upper edge of the switch bezel at the front and the rear to release the retainer clips
that secure the switch bezel to the door trim panel opening.
3. Pull the switch and bezel unit away from the door trim panel opening far enough to access and unplug the wire harness connector.
4. Remove the power window and lock switch and bezel unit from the door trim panel.
5. Reverse the removal procedures to install. When installing the switch and bezel unit to the door trim panel opening, insert the rear of the bezel into
the opening, then push down on the front of the bezel until the retaining tab snaps into place.
