RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Pedal Positioning Motor: Service and Repair
Installation
INSTALLATION
NOTE: Adjustable pedal cables are not serviceable. If they need service the adjustable pedal motor with the cables must be installed.
1. Install the adjustable pedal motor (1) with the cables.
2. Install the one mounting bolt (2) for the adjustable pedal motor (1).
3. Clip the cable fasteners to the support.
4. Reconnect the electrical connector.
5. Reconnect the adjustable pedal cables to the brake and accelerator pedals Also clutch pedal if equipped with a manual transmission.
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
6. Install a new brake lamp switch. See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp Switch - Installation.
7. Install the kneeblocker See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Steering Column
Opening Cover - Installation.
8. Reconnect the negative battery cable.
9. Check for proper operation of the pedals.