RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Installation
Front
CAB CHASSIS
1. Install the wiring to the clips and Reconnect the electrical connector.
2. Install the wheel speed sensor (2) to the hub (3).
3. Install the wheel speed sensor mounting bolt (1) to the hub (3). Tighten the bolt to 13 Nm (115 in. lbs.).
4. Install the front rotor and brake caliper assembly See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake
Rotor - Installation.
Rear
INSTALLATION
1. Connect the harness to the sensor. Be sure the seal is securely in place between the sensor and the wiring connector.
2. Install the O-ring on the sensor (if removed).
3. Insert the sensor (1) in the differential housing (3).
4. Install the sensor shield (if equipped).
5. Install the sensor mounting stud (2) and tighten to 24 Nm (200 in. lbs.).
6. Install the brake line on the sensor stud (2) and install the nut.
