RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic
brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the
area of repair instead of the entire system.
2. Raise and support the vehicle.
3. Remove the brake line (2) located at the axle.
4. Remove the mounting bolt (4) for the brake hose (3) at the axle.
5. Remove the banjo bolt (2) at the caliper.
6. Remove the hose (3).
Front Brake Hose - Heavy Duty (HD)
FRONT BRAKE HOSE - HEAVY DUTY (HD)
