RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
CAUTION: When installing the camshaft, DO NOT push it in farther than it will go with the thrust plate in place.
3. Install the camshaft and thrust plate. Align the timing marks as shown.
4. Install the thrust plate bolts and tighten to 24 Nm (18 ft. lbs.).
5. Measure camshaft back lash. Backlash should be within 0.075-0.250 mm (0.003-0.010 inch).
6. Measure camshaft end clearance. End clearance should be within 0.025 - 0.500 mm (0.001 - 0.020 inch).
7. Remove the wooden dowel rods and rubber bands from the tappets.
8. Lubricate the push rods with engine oil and install in their original location. Verify that they are seated in the tappets.
9. Lubricate the valve tips with engine oil and install the crossheads in their original locations.
10. Lubricate the crossheads and push rod sockets with engine oil and install the rocker arms and pedestals in their original locations. Tighten bolts to
36 Nm (27 ft. lbs.).
11. Verify valve lash adjustment See: Cylinder Head Assembly/Valve/Service and Repair/Procedures.
12. Install the cylinder head cover See: Cylinder Head Assembly/Valve Cover/Service and Repair/Removal and Replacement/Cylinder Head Cover(s)
