RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
4. Remove bolts and the block stiffener.
5. Using Miller Tool 7471B crankshaft barring tool, rotate the crankshaft so all of the pistons are below TDC.
6. Before removing the piston(s) from the bore(s):
a. Remove any carbon ridge formations or deposits at the top of the bore with a dull scraper or soft wire brush.
b. If cylinder bore wear ridges are found, use a ridge reamer to cut the ridge from the bore. DO NOT remove more metal than necessary to
remove the ridge.