RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Harmonic Balancer - Crankshaft Pulley: Removal and Replacement
Vibration Damper - Removal
REMOVAL
1. Remove the accessory drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Serpentine Accessory Drive
Belt - Removal.
2. Remove the four (4) damper to crankshaft bolts and remove damper.
Vibration Damper - Installation
INSTALLATION
1. Install the crankshaft damper and bolts. Tighten bolts to 40 Nm (30 ft. lbs.), plus an additional 60°.
NOTE: The damper must be installed so the hole is located over the dowel pin.
2. Install the accessory drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Serpentine Accessory Drive
Belt - Installation.