RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
1. Clean block surface, oil cooler, and oil cooler housing of debris, dirt and remaining gasket material.
NOTE: Depending on the revision of oil cooler, mounting gaskets will differ. Make sure the gaskets line up with the oil cooler element and
housing correctly. Failure to use correct gaskets will result in severe engine damage.
2. Using new gaskets (4) install the oil cooler (3) and the oil cooler housing (2) to engine block. Tighten the 14 capscrews in a crisscross pattern to
24 Nm (18 ft. lbs.).
3. Install the new oil filterSee: Oil Filter/Service and Repair/Removal and Replacement/Engine Oil Filter - Installation
4. Install the turbocharger oil supply line to the oil cooler housing. Tighten to 36 Nm (27 ft. lbs.).
