RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
19. Disconnect the camshaft position sensor connector.
20. Disconnect and remove engine speed sensor.
21. Remove the camshaft See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal and Replacement/Camshaft - Removal -
REMOVAL).
22. Remove the front six oil pan fasteners.
23. Remove the gear housing fasteners.
NOTE: Use care when removing the gear housing, to avoid damage to the oil pan gasket, as the gasket will be reused if it is not damaged.
24. Slide a feeler gauge between the gear housing and oil pan gasket, to break the gasket seal.
25. Remove the gear housing and gasket.
26. Clean the gasket material from the cylinder block and gear housing.
