RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Timing Cover: Service and Repair
Timing Case Front Housing - Installation
INSTALLATION
1. Inspect oil pan gasket. If torn, gasket must be replaced.
2. Install a new gear housing gasket onto cylinder block and trim any excess gasket material flush to oil pan rail.
3. Place a small amount of Mopar(R) engine RTV to the corners of the block and pan gasket T-joint to ensure a good seal.
4. Install the gear housing. Tighten bolts to 24 Nm (18 ft. lbs.).
5. If a new housing is installed, the camshaft position sensor, and engine speed sensor must be transferred to the new housing.
6. Connect the camshaft position sensor connector.
7. Install and connect engine speed sensor.
