Removal of Blend Door Actuator on RAM 3500 Chassis Cab Truck
2. Install the screws (1) that secure the blend door actuator (2) to the HVAC housing (3). Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Connect the HVAC wire harness connector (4) to the blend door actuator.
4. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation.
5. Reconnect the negative battery cable.
6. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
DUAL ZONE PASSENGER SIDE
1. Install the blend door actuator and bracket assembly (2) onto the top of the HVAC housing (3).
2. Install the screws (1) that secure the blend door actuator and bracket assembly to the HVAC housing. Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Connect the HVAC wire harness connector (4) to the blend door actuator.
