RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
INSTALLATION
1. Install the recirculation door actuator (1) onto the side of the HVAC air inlet housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those in the recirculation door actuator coupler (4).
2. Install the two screws (1) that secure the recirculation door actuator (2) to the air inlet housing (3). Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Connect the HVAC wire harness connector (4) to the recirculation door actuator.
4. If equipped, reinstall the amplifier See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Amplifier/Service and
Repair/Amplifier - Installation.
5. Install the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument Panel Glove Box -
Installation.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
