RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
1. Position the defroster duct (5) into the instrument panel.
2. Install the six screws (2) that secure the defroster duct to the instrument panel. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Install the defroster duct adapter (3) onto the defroster duct.
4. Install the screw (4) that secures the defroster duct adapter to the instrument panel support. Tighten the screw to 2.2 Nm (20 in. lbs.).
5. If removed, connect the center radio speaker wire harness connector (1) to the speaker.
6. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation.
Floor Distribution Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these
instructions may result in possible serious or fatal injury.
NOTE: Regular Cab model shown. Other models similar.
1. Remove the HVAC housing from the vehicle See: Housing Assembly HVAC/Service and Repair/Removal and Replacement/HVAC Housing -
Removal.
2. Remove the screws (3) that secure the floor distribution duct (1) to the bottom of the HVAC housing (2).
3. Remove the floor distribution duct from the HVAC housing.
Floor Distribution Duct - Installation
INSTALLATION
