RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Regular Cab model shown. Other models similar.
1. Position the floor distribution duct (1) onto the bottom of the HVAC housing (2).
2. Install the screws (3) that secure the floor distribution duct to the HVAC housing. Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Install the HVAC housing See: Housing Assembly HVAC/Service and Repair/Removal and Replacement/HVAC Housing - Installation.
Instrument Panel Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Take the proper precautions to protect the instrument panel from cosmetic damage.
1. Remove the instrument panel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Instrument Panel - Removal.
2. Remove the radio See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Radio/Stereo/Service and Repair/Removal and
Replacement/Radio - Removal.
3. Remove the defroster duct See: Defroster Duct - Removal.
4. Remove the two screws (1) that secure the center distribution duct (2) to the instrument panel support (3) and remove the duct.
