RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Engine Control Module: Procedures
TCM Quick Learn
TCM QUICK LEARN - AS68RC TRANSMISSION
NOTE: The ignition switch must be cycled to the OFF position after the AS68RC TCM quick learn procedure in order to initialize the TCM.
The quick learn procedure requires the use of the scan tool. Always check for and clear any codes after a quick learn is preformed. For scan tool step by
step instructions, reference the ECM/PCM/TCM Programming document, Quick Learn.
This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn
procedure should be performed if any of the following procedures are performed:
-
Transmission Assembly Replacement.
-
Transmission Control Module Replacement.
-
Clutch Plate and/or Seal Replacement.
-
Valve Body / Oil Pump Replacement.
To perform the Quick Learn Procedure, the following conditions must be met:
-
Turn off any electrical loads to insure the engine is at idle speed.
-
The transmission fluid temperature must be at or above 104°F (40°C).
-
Shift the lever from NEUTRAL to DRIVE and NEUTRAL to REVERSE three to five times to bleed off trapped in the transmission clutches and
brakes.
-
The shift lever position must stay in PARK until prompted to shift to another gear.
-
The parking brake must be applied and chock the rear wheels.
-
Both feet on the brake pedal.
-
PTO is inactive.
Flash Programming
FLASH PROGRAMMING
NOTE: The wiTECH diagnostic application is the preferred method for flashing ECUs.
NOTE: Help using the wiTECH diagnostic application for flashing an ECU is available by selecting "Help" then "Help Contents" at the top
of the wiTECH diagnostic application window.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: The StarMobile Desktop Client may also be used to perform this flash procedure.
SKREEM Programming
SKREEM PROGRAMMING
When a Powertrain Control Module (PCM) for a gasoline engine, or an Engine Control Module (ECM) for a diesel engine and the Sentry Key Remote
Entry Module (SKREEM) (also known as the Wireless Control Module/WCM) on vehicles equipped with the Sentry Key Immobilizer System (SKIS)
are replaced at the same time, perform the following steps in order:
NOTE: If the PCM and the SKREEM are replaced at the same time, program the PCM VIN into the PCM first.
1. If applicable first replace the PCM/ECM with the original WCM still connected to the vehicle.
2. Using the appropriate service information program the new PCM/ECM. (This will ensure the Secret Key Transfer from the original WCM into the
new PCM/ECM).
3. Now replace and program the WCM. This will retain the Secret Key from the PCM/ECM back into the new WCM.
4. With the scan tool, select Miscellaneous Functions, WCM/Wireless Control Module. Then select the desired procedure and follow the display on
the scan tool.
5. If the vehicle is equipped with Tire Pressure Monitoring System program the Placard Pressure Values into the WCM/SKREEM.
6. Ensure all the customer's keys have been programmed into the new module if necessary.
NOTE: If the original keys do not successfully program to the new SKREEM after the proper procedures are followed correctly,
