RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Fuel Level Sensor: Service and Repair
Fuel Pump Module - Removal
REMOVAL
1. Drain the fuel tank See: Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Procedures
2. Remove fuel tank See: Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Removal and Replacement/Fuel Tank - Removal
3. Note rotational position of module before attempting removal. An indexing arrow is located on top of module for this purpose.
4. Position SAE Fuel Pump Lock Ring Wrench 9340 (3) into notches on outside edge of lock ring (5).
5. Install 1/2 inch drive breaker bar (1) to SAE Fuel Pump Lock Ring Wrench 9340 (3).
6. Rotate breaker bar counterclockwise to remove lock ring.
7. Remove lock ring. The module will spring up slightly when lock ring is removed.
8. Remove module from fuel tank. Be careful not to bend float arm while removing.