RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
5. Be certain that the horn switch feed and ground pigtail wires are routed through the clearance notch at the top of the airbag housing (3), between
the housing and the upper vertical wall of the trim cover receptacle.
6. Work around the perimeter of the unit engaging each of the 12 hooks (5 and 6) on the driver airbag housing through the 12 windows in the walls of
the trim cover receptacle.
7. Install the horn switch ground pigtail wire eyelet terminal (2) over the upper right inflator stud on the back of the driver airbag housing.
8. Install and tighten the nut that secures the horn switch ground pigtail wire eyelet terminal to the upper right inflator stud on the back of the driver
airbag housing. Tighten the nut to 7 Nm (65 in. lbs.).
9. Using hand pressure, push the integral retainer of the horn switch feed pigtail wire connector (1) into the locator hole just above the upper right
inflator mounting stud on the back of the airbag housing.
10. After the driver airbag has been assembled, try pulling the trim cover and the airbag housing away from each other. This action will fully seat the
edges of the windows into the cradles of the hooks.
11. Before reinstalling the airbag onto the steering wheel, check that the blocking tab (1) in each of the trim cover windows is oriented over the airbag
housing hook (4) as shown.
12. Reinstall the driver airbag onto the steering wheel See: Removal and Replacement/Driver Air Bag - Installation.