RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Belt Arming and Disarming: Service and Repair
WARNING: To avoid potential physical injury or damage to sensitive electronic circuits and systems, always disconnect and isolate the battery
negative (ground) cable and the positive cable, then ground the positive cable to discharge the Occupant Restraint Controller
(ORC) capacitor before performing any welding operations on the vehicle. Failure to take the proper precautions could result in
accidental airbag deployment, possible damage to the Supplemental Restraint System (SRS) circuits and components, and possible
damage to other electronic circuits and components. Whenever a welding process is being performed within 12 inches (30
centimeters) of an electronic module or wiring harness, then that module or harness should be relocated out of the way, or
disconnected. Always protect against component or vehicle damage from weld spatter by using weld blankets and screens.
