RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
13. Position the seat belt (2) lower anchor to the mounting hole on the outboard side of the front seat (1) cushion frame. Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
14. Install and tighten the screw (3) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
15. Reinstall the lower anchor cover (4) onto the front seat cushion outboard side shield.
16. Reinstall the stowage tray onto the rear floor panel behind the seat. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Load Floor - Installation.
17. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures.
Rear Center - Mega Cab
REAR CENTER - MEGA CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism. See: Description and
Operation/Seat Belt Retractor - Description .
1. Position the rear center seat belt and retractor unit into the 60 percent of the rear seat back frame (3). Be certain the tab (5) on the retractor bracket
is engaged in the slot in the frame.
2. Install and tighten the screw (4) that secures the rear center seat belt retractor to the seat back frame. Tighten the screw to 60 Nm (44 ft. lbs.).
