RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and
unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in possible serious
or fatal injury.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism. See: Description and
Operation/Seat Belt Retractor - Description .
1. Position the rear outboard seat belt and retractor (4) to the inner C-pillar as a unit. Be certain to engage the hooks on the upper retractor bracket
into the mounting hole in the C-pillar.
2. Install and tighten the screw (3) that secures the lower retractor bracket to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
3. Position the belt web guide (5) to the B-pillar and use hand pressure to press it firmly and evenly until the two clips that secure it snap into place.
4. Reinstall the lower trim (2) onto the inside of the C-pillar. Be certain that the turning loop (1) can be accessed from the face of the lower trim after
the seat belt webbing is inserted through the slot in the trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel - Installation.
5. Reinstall the upper trim (1) onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel - Installation.
6. Position the seat belt turning loop (2) onto the upper C-pillar.
7. Install and tighten the screw (4) that secures the turning loop to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
8. Engage the upper edge of a new trim cover (3) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
9. Position the seat belt lower anchor (6) to the mounting hole at the base of the C-pillar.
10. Install and tighten the screw (5) that secures the lower anchor to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Reinstall the rear seat into the vehicle. See: Body and Frame/Seats/Service and Repair/Seat, Center/Seat - Installation.