RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Water In Fuel Sensor: Service and Repair
Removal
REMOVAL - Water-In-Fuel (WIF) Sensor
1. With engine not running, Route the fuel drain hose to an appropriate container and rotate drain valve (4) one quarter turn counter clockwise to
open it. Also, loosen the fuel filter housing cover a 1/2 turn and allow the fuel drain from the fuel filter housing for two minutes. Rotate the drain
valve (4) clockwise one quarter turn to close it.
2. Disconnect the Water In Fuel (WIF) sensor harness connector (2).
3. Remove the WIF sensor (3).
