RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Battery Tray: Service and Repair
Battery Tray - Removal
REMOVAL
LEFT SIDE
1. Remove the battery (3) from the battery tray See: Service and Repair/Removal and Replacement/Battery - Removal.
2. Remove the Totally Integrated Power Module (TIPM) (5)See: Power and Ground Distribution/Power Distribution Module/Service and
Repair/Totally Integrated Power Module (TIPM) - Removal.
3. Disconnect the wire harness retainers from the battery tray assembly.
4. Disconnect the purge solenoid (6) from its mounting bracket.
5. Remove the anti-lock brake controller (if equipped) retaining bolts and support the brake controller with mechanics wire. It is not necessary to
completely remove the anti-lock brake control unit.
6. Remove the left front wheelhouse splash shieldSee: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Splash Shield -
Removal.
7. Mark the location of the cruise servo (3) (if equipped) and remove the retaining screws. Position the servo out of the way.
8. Remove the battery temperature sensor from the battery tray See: Battery Temperature Sensor/Service and Repair/Battery Temperature Sensor -
Removal.
9. Disconnect the left front fender ground wire.
10. Remove the remaining battery tray retaining bolts (2).
11. Remove the battery tray from the vehicle.
RIGHT SIDE