RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Alternator: Service and Repair
Generator - Installation
DIESEL
1. Position generator to upper and lower mounting brackets and install upper bolt and lower bolt / nut.
2. Tighten all bolts/nut to 30 ft. lbs. (41 Nm).
3. Snap field wire connector into rear of generator.
4. Install B+ terminal eyelet to generator output stud. Tighten mounting nut. Refer to Torque Specifications.
CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
CAUTION: When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong
direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or
Refer to the Belt Schematics in Cooling System.
5. Install generator drive belt. Refer to Cooling System for procedure.
6. Install both negative battery cables to both batteries.