RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Starter Motor: Service and Repair
Starter - Installation
DIESEL
5.9L Diesel
1. If Equipped: Position and hold aluminum spacer to rear of starter while positioning starter to engine.
2. Connect solenoid wire to starter motor. Tighten nut to 4.4 ft. lbs. (6 Nm).
3. Position battery cable to starter stud. Install and tighten battery cable nut to 10.3 ft. lbs. (14 Nm). Do not allow starter motor to hang from wire
harness.
4. Position starter motor to transmission.
5. If equipped with automatic transmission, slide cooler tube bracket into position.
6. Install and tighten 3 starter mounting bolts to 32 ft. lbs. (43 Nm).
7. Lower vehicle.
8. Connect both negative battery cables to both batteries.
6.7L Diesel
1. Connect solenoid wire to starter motor. Tighten nut to 4.4 ft. lbs. (6 Nm).
2. Position battery cable to starter stud. Install and tighten battery cable nut to 10.3 ft. lbs. (14 Nm). Do not allow starter motor to hang from wire
harness.
3. Position starter motor to transmission.
4. Install and tighten 3 starter mounting bolts to 32 ft. lbs. (43 Nm).
5. Lower vehicle.
6. Connect both negative battery cables to both batteries.
