RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
1. Set the power steering pump (1) in place in the engine compartment from the bottom.
2. Install 3 pump mounting bolts through the pulley access holes. Tighten the bolts to 28 Nm (21 ft. lbs.).
3. Reconnect the pressure line (4) and return hose (3) to the pump and reservoir. Tighten the pressure line to 37 Nm (27 ft. lbs.).
4. Tighten the pump bracket bolt (3) to the block.
5. Install the serpentine drive belt, See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Serpentine Accessory Drive Belt - Installation.
6. Fill the power steering pump, See: Procedures.
Power Steering Pump Pulley - Removal
REMOVAL
