RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Stabilizer Bushing: Service and Repair
Rear Suspension Bushing(s) - Removal
REMOVAL
CAUTION: Handling of springs must be done with care. Impact marks or nicks as small as 0.5 mm (0.0196 in.) deep in the spring eye or in the
leaf incorporating the eye may result in premature spring failure.
1. Remove the spring from the vehicle See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Suspension Leaf Spring(s) - Removal.
2. Make small relief cuts in the flared up end of the bushing metal being careful not to cut the spring. Use a punch to bend the flared bushing metal
down for push out.
3. Position the spring eye in a press.
4. Press the bushing out with an appropriate size driver.
