RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Torque Converter: Service and Repair
Torque Converter - Installation
INSTALLATION
NOTE: Check converter hub and drive flats for sharp edges, burrs, scratches, or nicks. Polish the hub and flats with 800/10000 grit paper or
crocus cloth if necessary. Verify that the oil pump seal is properly installed and is free from debris. The hub must be smooth to avoid
damaging the pump seal at installation.
TC REMOVAL
1. Lubricate oil pump seal lip and input shaft seal rings with MOPAR(R) AS68RC ATF.
WARNING: Be certain the transmission is secure when installing the torque converter, the torque converter is very heavy. Failure to follow
these instructions may result in personal injury or may be fatal.
2. Place torque converter in position on transmission.
CAUTION: Do not damage oil pump seal or input shaft seal rings while inserting torque converter into the front of the transmission.
3. Align torque converter to oil pump seal opening.
4. Insert torque converter hub into oil pump.
5. While pushing torque converter inward, rotate converter until converter is fully seated in the oil pump gears.
6. Install the transmission into the vehicle.See: Service and Repair/Removal and Replacement/Installation
