RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Installation
Power
INSTALLATION
1. Connect the door wire harness (4) to the window regulator and install the regulator through the opening in the door.
2. Engage the two regulator bolts (3) to the door.
3. Install the regulator bolts (2) that secures the window regulator to the door and tighten all regulator bolts to 10 Nm (89 in. lbs.).
4. Position the regulator stabilizer into the door and install the two nuts. Tighten the nuts to 10 Nm (89 in. lbs.).
5. Raise the window regulator (3) to the position shown.
6. Support the door glass (2) and remove the wooden wedge or equivalent.
7. Position the door glass to the window regulator and install the two nuts (1) that secure the door glass to the window regulator (3) through the sight
window (4) and the speaker opening (5). Tighten the nuts to 10 Nm (89 in. lbs.).
8. Disconnect the electric window switch from the door wire harness and reinstall the switch onto the door trim panel See: Power Window
Switch/Service and Repair/Power Window Switch - Installation.
9. Install the waterdam See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Watershield -
Installation.
10. Install the inner belt molding See: Window Glass/Front Door Window Glass/Front Door Window Glass Weatherstrip/Service and Repair/Front
Door Molding - Installation.
Manual
INSTALLATION
