RAM 3500 Chassis Cab Truck 2WD V8-5.7L (2011)
Tire Monitoring System: Service and Repair
Perform one of the following to make the system learn the new sensor ID.
a. Use the TPM-RKE Analyzer, 9936, with the Scan Tool to program the WIN with the tire pressure sensor ID. This is part of the TPM Diagnostic
Verification Test.
b. Once the vehicle has remained stationary for more than 20 minutes, drive vehicle for a minimum of 10 minutes while maintaining a continuous
speed above 15 mph (24 km/h). During this time, the system will learn the new sensor ID. This is part of the TPM Diagnostic Verification Test.
NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.
