RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Lower Side Moulding / Trim: Service and Repair
Removal
REMOVAL
NOTE: Quad Cab model shown in the illustration. Body side moldings for Regular cab models are similar.
1. As a guide for installation, apply a length of masking tape on the rocker panels (1), parallel to the top edge and, to one end of the body side
molding (2 and 3) being removed
CAUTION: Do not exceed 52° C (120° F) when heating the moldings or rocker panels. Failure to follow this caution may result in damage
to the moldings and/or the vehicle paint finish.
2. If the temperature is below 21° C (70° F), warm the body side moldings with a heat lamp or heat gun.
NOTE: The body side moldings are attached to the cab with adhesive tape.
3. Using a trim stick C-4755 or equivalent, carefully remove the moldings from the rocker panels, as necessary.
