RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Passenger Assist Handle: Service and Repair
A-Pillar Trim/Grab Handle
Removal
REMOVAL
1. Using a small flat-bladed tool, carefully open the two fastener covers (3) located in the a-pillar trim panel (2).
2. Remove the two bolts (4) that secure the a-pillar trim panel to the a-pillar (1) and remove the trim panel.
Installation
INSTALLATION
1. Position the locating tab of the A-pillar trim panel (2) into the slot located in the top of the instrument panel.
2. Install the A-pillar trim panel onto the A-pillar (1) and install the two bolts (4). Tighten the bolts to 6 Nm (55 in. lbs.).
3. Close the two fastener covers (3) located in the A-pillar trim panel.
