RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
1. If equipped, connect the door wire harness to the power door switch assembly.
CAUTION: The door trim panel is attached to the door by molded plastic retaining clips that are integral to the door trim panel. Do not
force the door trim panel onto the door or damage to the trim panel and/or the power switch assembly will occur.
2. Position the door trim panel (3) and align the molded plastic retaining clips (5) to the door.
3. Push the door trim panel straight downward until all of the retaining clips are fully engaged to the door.
4. Install the two screws (2) that secure the door trim panel to the two screw inserts (1).
5. Install the two screws (4) that secure the door trim panel to the bottom of the door.
6. If equipped, install the manual window crank.
7. Position the interior door handle (2) onto the interior door handle actuator (3).
8. Install the screw (1) that secures the interior door handle to the interior door handle actuator. Tighten the screw securely.
Load Floor - Removal
REMOVAL
1. Move the rear seat cushion (1) to the up position.
2. Remove the two nuts (2) that secure the rear of the load floor (3) to the floor panel.
