RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Seat Back: Service and Repair
Removal
REMOVAL
1. Before proceeding with the following repair procedure, review all warnings and cautions. See: Restraint Systems/Service Precautions
NOTE: Do not reuse the seat fasteners, always replace with new ones.
2. Remove the center seat See: Service and Repair/Seat - Removal .
3. Disconnect the storage bin/cushion cover j-straps and position aside.
4. Remove and discard the hinge bolts (2) and separate the seat back from the storage bin/cushion (1).
Installation
INSTALLATION
1. Before proceeding with the following repair procedure, review all warnings and cautions. See: Restraint Systems/Service Precautions
NOTE: Do not reuse the seat fasteners, always replace with new ones.
2. Install the seat back onto the storage bin/cushion (1) and install new hinge bolts (2).
3. Tighten the hinge to storage bin/cushion bolts (2) to 25 Nm (18 ft. lbs.).
4. Connect the storage bin/cushion cover j-straps.
5. Install the center seat See: Service and Repair/Seat - Installation .
Removal
REMOVAL
