dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Center Seat Cushion Cover|Page 13923 > < Center Seat Cushion Cover|Page 13921
Page 2
background image

1. Install the seat cushion frame (2) onto the rear seat cushion hinges (4).
2. Install the bolts (3) and tighten to 85 Nm (63 ft. lbs.).
3. Install the seat cushion/cover  See: Seat Cushion / Cover - Installation .

Front Seat

REMOVAL

1. Remove the front seat.  See: Service and Repair/Seat - Removal
2. Remove the screw and remove the recliner handle.
3. Remove the two screws and remove the power seat controls, if equipped, and disconnect the electrical connector.
4. Disconnect the j-straps and remove the seat cushion and cover.

Rear Seat

REMOVAL

1. Remove the rear seat.  See: Service and Repair/Seat - Removal
2. Separate the zip strip at the rear of the seat cushion and remove the cushion and cover.

Rear Seat - Mega Cab

REMOVAL

1. Fold both rear seats flat.
2. Remove the filler panels from the rear seat to storage compartment.
3. Separate the J-straps at the bottom of the seat back.
4. Remove both hinge covers from the back section being worked on.
5. Remove the lower anchor for the center seat belt.
6. Disconnect the lower cable attachment from the seat back release.
7. Remove the four bolts and remove the seat back from the seat.
8. Remove the screw and remove the seat back release bezel.
9. Mark the location of the release cables at the cushion and remove.

10. Remove the upper cushion pivot bolts.
11. Remove the lower cushion pivot bolts.
12. Remove the cushion from the seat.
13. Remove the seat release lever from the cushion.
14. Separate the J-straps securing the cover to the seat pan.
15. Remove the foam and cover from the seat pan.
16. Separate the foam from the cover.

Front Seat

INSTALLATION

1. Position the seat cushion and cover onto the frame assembly and connect the j-straps.
2. Connect the power seat control switch electrical connector, if equipped.
3. Install the power seat control switch and install the two screws, if equipped.
4. Install the recliner handle and install the screw.
5. Install the front seat.  See: Service and Repair/Seat - Installation

Rear Seat

INSTALLATION

Center Seat Cushion Cover|Page 13923 > < Center Seat Cushion Cover|Page 13921