RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
1. Raise and support the vehicle.
2. Remove the front wheel and tire assembly.
3. Remove the caliper slide pin bolts (1) See: Disc Brake Caliper - Removal .
4. Remove the disc brake caliper (2) from the adapter.
CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable
support to hang the caliper securely.
5. Remove the brake pads. See: Brake Pad/Service and Repair/Brake Pads - Removal .
6. Remove the caliper adapter mounting bolts (5).
7. Remove the caliper slide pins from the adapter.
Rear
REAR
1. Install the caliper adapter mounting bolts (4). Tighten the mounting bolts to 135 Nm (100 ft.lbs) LD or tighten to 197 Nm (145 ft.lbs.) HD.
2. Install the anti-rattle clips (2).
3. Install the inboard and outboard pads (1).