RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
7. Reduce the inside diameter measurement of the brake drum that was taken using Special Tool C-3919 (2) by 1/64 of an inch. Reset Gauge, Brake
Shoe, Special Tool C-3919 (2) or the equivalent used, so that the outside measurement jaws are set to the reduced measurement.
8. Place Gauge, Brake Shoe, Special Tool C-3919, or equivalent over the park brake shoes. The special tool must be located diagonally across at the
top of one shoe and bottom of opposite shoe (widest point) of the park brake shoes.
9. Using the star wheel adjuster, adjust the park brake shoes until the lining on the park brake shoes just touches the jaws on the special tool.
10. Repeat step 8 above and measure shoes in both directions.
11. Install brake rotor on the axle shaft See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor -
Installation .
12. Rotate rotor to verify that the park brake shoes are not dragging on the brake drum. If park brake shoes are dragging, remove rotor and back off
star wheel adjuster one notch and recheck for brake shoe drag against drum. Continue with the previous step until brake shoes are not dragging on
brake drum.
13. Install disc brake caliper on caliper adapter See: Disc Brake System/Brake Caliper/Service and Repair/Removal and Replacement/Disc Brake
Caliper - Installation .
14. Install wheel and tire.
15. Tighten the wheel mounting nuts in the proper sequence until all nuts are torqued to half the specified torque. Then repeat the tightening sequence
to the full specified torque of 129 Nm (95 ft. lbs.) LD , 197 Nm (145 ft. lbs.) HD SRW , 210 Nm (155 ft. lbs.) HD DRW.
16. Lower vehicle.
17. Apply and release the park brake pedal one time. This will seat and correctly adjust the park brake cables.
CAUTION: Before moving vehicle, pump brake pedal several times to ensure the vehicle has a firm enough pedal to stop the vehicle.
18. Road test the vehicle to ensure proper function of the vehicle's brake system.
