RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
4. The top surface of all of the compression rings are identified with the word TOP or the supplier's MARK. Assemble the rings with the word TOP
or the supplier's MARK up.
5. Position the oil ring expander (2) in the oil control ring (1) groove (bottom groove).
NOTE: There is no (TOP) mark on the oil ring.
6. Install the oil control ring (1) with the end gap OPPOSITE the ends on the expander.
7. Install the intermediate piston ring in the second groove.
8. Install the top piston ring in the top groove.
9. Position the rings as shown.
-
Install top and second compression rings on piston with ring gaps 180° apart.
-
Install oil control ring with ring gap 90° from top and second ring. Do not position gaps over wrist pin hole.
