RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure Sensor/Switch - Installation
INSTALLATION
1. Install banjo screw through the oil pressure switch mounting block. The switch mounting block port (oil switch port) should point to the 2 o'clock
position. Torque the banjo screw to 24 Nm or 18 ft lbs.
2. If the switch is not being replaced, replace and lubricate the o-ring.
3. Install the oil pressure switch and tighten to 18 Nm (159 in. lbs.) torque.
4. Connect oil pressure switch connector.
5. Connect the battery negative cables.
6. Start engine and check for oil leaks at the switch.
