RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
9. Position the tilt steering column knob (1) onto the tilt adjuster actuator (3) on the left side of the steering column, then install and tighten the screw
(2) to secure the knob to the actuator. Tighten the screw to 2 Nm (20 in. lbs.).
NOTE: When reinstalling the steering wheel, be certain to index the yellow rubber booted engagement dowel on the upper surface of the
clockspring rotor between the two fins cast into the lower surface of the steering wheel armature hub.
10. Reinstall the steering wheel onto the steering column. See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation .
11. Reconnect the steering wheel wire harness connectors to the upper clockspring connector receptacles. Be certain that the steering wheel wire
harness is routed between the steering wheel back trim cover and the steering wheel armature.
12. Reinstall the driver airbag onto the steering wheel. See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Driver Airbag - Installation .
13. Reconnect the battery negative cable.
