RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Power Distribution Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the B+ terminal nut (6) from the Totally Integrated Power Module (2)(TIPM) B+ terminal. Remove the B+ cable (5) from the TIPM (2).
3. Using a suitable flat blade tool, disengage the TIPM (2) upper retaining tabs from the battery tray bracket (3).
4. Grasp the TIPM (1) and rotate the assembly up to free it from its mounting bracket (3). Position the assembly upside down to access the electrical
connectors located on the bottom of the unit.
5. Disconnect the electrical connectors (2) by depressing the locking tab and rotating the connector arm outboard, until the connector is free from the
