RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
All involved vehicles have been entered into the DealerCONNECT Global Recall System (GRS) and Vehicle Information Plus (VIP) for dealer inquiry
as needed.
GRS provides involved dealers with an updated VIN list of their incomplete vehicles. The owner's name, address and phone number are listed if known.
Completed vehicles are removed from GRS within several days of repair claim submission.
To use this system, click on the "Service" tab and then click on "Global Recall System." Your dealer's VIN list for each recall displayed can be sorted
by: those vehicles that were unsold at recall launch, those with a phone number, city, zip code, or VIN sequence.
Dealers must perform this repair on all unsold vehicles before retail delivery. Dealers should also use the VIN list to follow up with all owners to
schedule appointments for this repair.
Recall VIN lists may contain confidential, restricted owner name and address information that was obtained from the Department of Motor Vehicles of
various states. Use of this information is permitted for this recall only and is strictly prohibited from all other use.
Additional Information
If you have any questions or need assistance in completing this action, please contact your Service and Parts District Manager.
Customer Services Field Operations
Chrysler LLC
A. Replace the Oxygen Sensor Module
1.
Open the hood and disconnect the negative battery cables from both batteries.
2.
Using a mechanic's creeper, slide under the right side of the truck and locate the oxygen sensor module on the outer side of the right frame rail
(Figure 1).
3.
Disconnect the electrical connector at the oxygen sensor module (Figure 1).
4.
Remove the four oxygen sensor module mounting bolts (Figure 1).
5.
Remove and discard the original oxygen sensor module from frame rail.
6.
Position the new oxygen sensor module onto the frame rail.
7.
Install the four oxygen sensor module mounting bolts.
8.
Tighten the oxygen sensor module mounting bolts to 53 in. lbs. (6 N.m).
9.
Connect the oxygen sensor module electrical connector to the module.
10.
Connect the negative battery cables.
