RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Oxygen Sensor: All Technical Service Bulletins
Engine Controls - Oxygen Sensor Testing Information
NUMBER: 08-035-08
GROUP: Electrical
DATE: November 21, 2008
SUBJECT:
Proper Testing Tools For Oxygen Sensor Terminals
OVERVIEW:
This bulletin describes the use of proper test probes to test the Oxygen (02) Sensor connector terminals equipped with the new TP2 style of sensor.
MODELS:
2007-2009
(DH)
2500 Pick Up
2007-2009
(D1)
3500 Pick Up
NOTE:
This bulletin applies to models equipped with a Cummins 6.7L engine (sales code ETJ).
DISCUSSION:
The new TP2 style 02 sensors have smaller terminals that may be damaged (spread) when using standard Digital Volt Ohm Meter (DVOM) test probes.
The recommended tool for these testing procedures is the Miller Tool # 6801 (Fig. 1)
Two (2) of these probes are required when performing circuit tests as described in DealerCONNECT. The tool was originally included as part of Miller
Tool # 6807 and # 8197A. Each of these kits contained one (1) # 6801 terminal probe. Two (2) additional Miller test probes # 6801 will be delivered to
affected Dodge dealers shortly.
Two (2) new terminal probes (# 6801) will be included and shipped as kit # 10190.
POLICY:
Information Only
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
