RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
a. Select "Browse for New File". Follow the on screen instructions.
b. Enter your "User id" and "Password", then select "OK".
c. If the newly downloaded flash file "Part Number" description is the same as the number recorded in Step 6e, then the PCM is up to date.
Continue to Step 12.
If the part numbers are not the same, continue to Step 7d.
d. Highlight the listed calibration on the StarMOBILE screen.
e. Select "Download to Client".
f.
Select "Close" after the download is complete, then select the "Back" arrow.
g. Highlight the listed calibration.
h. Select "Update Controller" and follow the on screen instructions.
i.
When the update is completed, select "OK".
8. Disconnect the StarMOBILE vehicle cable from the vehicle.
9. Turn off the StarMOBILE scan tool and then restart the scan tool.
NOTE:
The StarMOBILE scan tool must be shut down and restarted to unlock the flash.
10. Retrieve the PCM part number. With the StarMOBILE on the "Home" screen, follow the procedure below:
a. Select "ECU View".
b. Select "PCM" in the list of modules.
c. Select "More Options".
d. Select "ECU Flash".
e. Verify the "Part Number" (displayed at the end of the "Resident flash file for" statement) has been updated to the new part number. If it has
updated, then the flash has been completed successfully.
11. Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the ECM programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
a. From the "Home" screen select "System View".
b. Select "All DTCs".
c. Press "Clear All Stored DTCs" if there are any DTCs shown on the list.
12. Turn the ignition key to the "OFF" position and remove the StarMOBILE unit, StarMOBILE vehicle cable, and battery charger from the vehicle.
13. Continue with Section D. Install Authorized Modification Label.
D. Install the Authorized Modifications Label:
