RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Oxygen Sensor: Service and Repair
Oxygen Sensor Module
Removal - Pick Up Models
REMOVAL - PICK UP MODELS
The oxygen sensor module (1) is located under the vehicle. It is bolted to the outer side of right frame rail (4).
1. Raise and support vehicle.
2. Disconnect electrical connector (2) at module (1).
3. Remove four bolts (3).
4. Remove module from frame rail.
Installation - Pick Up Models
INSTALLATION - PICK UP MODELS
The oxygen sensor module (1) is located under the vehicle. It is bolted to the outer side of right frame rail (4).
1. Position module (1) to frame rail (4).
2. Install four bolts (3).
3. Tighten bolts (3) to 6 Nm (53 in. lbs.) torque.
4. Connect electrical connector (2) to module (1).
5. Lower vehicle.