RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
EGR Tube: Service and Repair
Removal
Removal-Cab/Chassis Models
INSTALLATION-CAB/CHASSIS MODELS
1. Clean each end of EGR crossover tube, and its connection points of any old gasket material
2. Install new gaskets (doughnuts) to each end of tube.
3. Position EGR crossover tube (2) to engine.
4. Position "P" clamp (5) at center of EGR crossover tube. Install "P" clamp bolt loosely (finger tight).
5. First, tighten EGR tube clamp (1) to 10 Nm (7 ft. lbs.), then tighten clamp (3) to 10 Nm (7 ft. lbs.).
6. Tighten "P" clamp bolt (5) to 10 Nm (7 ft. lbs.).
7. Connect electrical connector (4) to EGR temperature sensor.
8. Install heat shield (2) over EGR valve (1).
