RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
4. Disconnect electrical connector (4) at EGR Temperature Sensor.
5. Loosen and remove two clamps (1) and (3) at ends of EGR Crossover Tube.
6. Remove "P" clamp mounting bolt (5) at center of EGR Crossover Tube.
7. Remove EGR Crossover Tube (2).
8. Remove and discard gaskets (doughnuts) at each end of tube.
Installation-Pick Up Models
REMOVAL-PICK UP MODELS
1. Disconnect and isolate both negative battery cables at batteries.
2. Remove four bolts (2) and EGR crossover tube cover (1).
