RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
a. Select "ECU View".
b. Select "PCM" in the list of modules.
c. Select "More Options".
d. Select "ECU Flash".
e. Verify the "Part Number" (displayed at the end of the "Resident flash file for" statement) has been updated to the new part number. If it has
updated, then the flash has been completed successfully.
10. Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the ECM programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
a. From the "Home" screen select "System View".
b. Select "All DTCs".
c. Press "Clear All Stored DTCs" if there are any DTCs shown on the list.
11. Turn the ignition key to the "OFF" position and remove the StarSCAN unit, StarSCAN cable, StarSCAN ethernet cable and battery charger from
the vehicle.
12. Continue with Section D. Install Authorized Modification Label.
C. Reprogram the ECM Using StarMOBILE:
CAUTION:
On 2007 model year trucks, verify that Emissions Recall G30 has been completed prior to performing this notification. Recall G30 contains
"bootloader" software that must be installed to prevent damage to the ECM.
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during the
flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand alone voltmeter. The battery charger volt meter may not be sufficiently accurate. Voltages outside of the specified range will
cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor
to lower the voltage.
2. Connect the StarMOBILE scan tool to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN"
position.
3. Power ON the StarMOBILE scan tool.
4. From the desktop, launch the "StarMOBILE Desktop Client" software.
5. Establish a connection with the StarMOBILE scan tool.
6. Retrieve the old PCM part number. With the StarMOBILE on the "Home" screen, follow the procedure below:
a. Select "ECU View".
b. Select "PCM" in the list of modules.
c. Select "More Options".
d. Select "ECU Flash".
e. Record the "Part Number" displayed at the end of the "Resident flash file for" statement near the top of "Flash PCM" screen for later reference.
7. Download the flash file from the internet to the StarMOBILE. With the StarMOBILE on the "Flash PCM" screen, follow the procedure below:
