RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
1. Adjust the front seat to its most forward position for easiest access to the front seat belt (2) lower anchor cover (4) and the B-pillar trim.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
3. Grasp the upper edge of the lower anchor cover and pull upward to unsnap it from the front seat cushion outboard side shield.
4. Remove the screw (3) that secures the lower anchor to the outboard side of the front seat cushion frame.
5. Unsnap the trim cover (3) from the front seat belt turning loop (5) and discard.
6. Remove the screw (4) that secures the seat belt turning loop to the height adjuster (1) on the upper B-pillar.
7. Remove the seat belt turning loop from the height adjuster.
8. Remove the upper trim (2) from the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim .
9. Remove the lower trim (3) from the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim .
10. On light-duty DR 1500 only, disconnect the yellow body wire harness connector (5) from the seat belt tensioner initiator on the retractor (7).
